[PLUG] ZTE MC315 Reliance RConnect on Linux...

Satish K. Pagare asatsi at hotmail.com
Fri May 12 14:20:28 IST 2006


Hello all,

Anyone got this new ZTE MC315 card from Reliance (Rconnect) working under 
linux?
I am on RH FC5.

As soon as I insert the card it gets detected and I see following message in 
"dmesg"
<snip>
pccard: PCMCIA card inserted into slot 0
cs: memory probe 0xd0000000-0xd7ffffff: excluding 0xd0000000-0xd7ffffff
cs: memory probe 0xb4000000-0xbfffffff: excluding 0xb4000000-0xb47fffff 
0xb6000000-0xb7ffffff
pcmcia: registering new device pcmcia0.0
ttyS3: detected caps 00000700 should be 00000100
0.0: ttyS3 at I/O 0x2e8 (irq = 3) is a 16C950/954
</snip>

setserial shows :-
[root at hominid ~]# setserial -av /dev/ttyS3
/dev/ttyS3, Line 3, UART: 16950/954, Port: 0x02e8, IRQ: 3
Baud_base: 115200, close_delay: 50, divisor: 0
closing_wait: 3000
Flags: spd_normal skip_test

But using minicom or wvdial doesn't yield any results.

Here's the output from wvdialconf
<snip>
[root at hominid ~]# wvdialconf test.conf
Scanning your serial ports for a modem.

ttyS0<*1>: ATQ0 V1 E1 -- failed with 2400 baud, next try: 9600 baud
ttyS0<*1>: ATQ0 V1 E1 -- failed with 9600 baud, next try: 115200 baud
ttyS0<*1>: ATQ0 V1 E1 -- and failed too at 115200, giving up.
Port Scan<*1>: S1 S2
ttyS3<*1>: ATQ0 V1 E1 -- failed with 2400 baud, next try: 9600 baud
ttyS3<*1>: ATQ0 V1 E1 -- failed with 9600 baud, next try: 115200 baud
ttyS3<*1>: ATQ0 V1 E1 -- and failed too at 115200, giving up.


Sorry, no modem was detected! Is it in use by another program?
Did you configure it properly with setserial?
</snip>

Anyone had any luck with this card ?

Thanks and Regards,
Satish/
:------------------------------------------------------------:
  There is no dark side of the moon, its all dark over there.
  And Pink Floyd is not a person , they are a band.
:------------------------------------------------------------:
Satish K. Pagare
Visit me : http://www.geocities.com/asatsi






More information about the Plug-mail mailing list